News Stories

Siemens Partner Status: Supporting enhanced services to NDC customers

an Autobond Compact T Laminator

(September 2010)

As a Siemens Drives & Transmissions Partner, NDC has recently completed the overhaul and refurbishment of the servo control system from an Autobond Compact T Laminator.

The customer had been experiencing nuisance trips over the past few months which quickly started to effect the manufacturing efficiency. The laminator uses a three-axis Simovert MC system, which NDC site engineers diagnosed as faulty and removed for repair and overhaul.

Because of the importance of the machine, the decision was taken to remove the 1FT6 series servomotors and overhaul them at the same time to minimise the possibility of any future unscheduled stoppages.

The work was completed in 3 days from the initial call to full production being resumed. In a follow-up call from the site engineer to check on the machine, it was agreed that the customer should hold a good stock of motor and drive spares for the machine, which, as a Siemens Drives & Transmission Partner, NDC could supply within 4 days.

Back to news

© 2012 - 2018 NDC - all rights reserved

Terms and ConditionsPrivacy Policy